Programing Error Codes


T.Creemer

Recommended Posts

  • 2 weeks later...

I did get past the problem, but with no resolution on the the error codes.  I have control lines from several analog multiplexers connected to the free port I/O pins.  For some reason during programing, power must be applied to these devices.  Apparently they are holding I/O lines on the FPGA in a state that causes the issue.  

Thanks for checking.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.