Does the board work?


Recommended Posts

Where do most basic support type questions get asked?


I just got a 250k Papilio One. I attempt to load the quick start. I don't see an ascii table.


I do see some green flickers, red power led, successful loading indicated in the ide window.


I don't have a wing.



Link to comment
Share on other sites

Hello JohnK,


This is a good place for your question. What kind of terminal program are you using to see the ascii table? Are you connecting to the second serial port that shows up? Do you have the correct speed? It should be 9600 8N1 if I'm not mistaken.


Here is a video showing how to determine the serial port:



Link to comment
Share on other sites

Hi Jack,

I am using the Zap IDE with AVR8 Shifty 250k Papilio One.

I tried again today and it works. Not sure what has changed. It's on the second additional enumerated USB port, and am using the Arduino IDE monitor.

Output seems as as expected. Sigh - what did I change? Oh well. (The drivers are 1/24/14 Microsoft stuff.)


Thanks for the reply, btw.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.