offroad Posted January 24, 2014 Report Share Posted January 24, 2014 "Ouch", because at the end of a long and painful debug process came the insight that the 2nd ADC on my board is broken. Works only when I push it down... will try resolder it tomorrow. Edit: Fixed.. the little fella had one foot off the dancefloor. Anyway, one result is an ADC demo that got out of necessity a little more polished than planned. Controls LED brightness with input 1 (the one closest to the SD card). The signal pin faces the edge of the board. Dumps all 16 channels through USB. Set up virtual com port for the 2nd USB interface, open Teraterm and connect with default settings (9600 baud, 8 bits, 1 stop bit) There is some information out there regarding control of this ADC that I find questionable, after reading the data sheet (It states explicitly that there are no timing requirements between falling edges of CS and CLK so they may change in the same cycle and the whole control logic simplifies greatly) ADCs run at 50 % of maximum throughput, that is, they take turns. 8 frames are captured in one shot. The data sheet shows 10 bits even though it's an 8-bit ADC. The implementation picks the correct ones, others are apparently zero (edit: no they are not - you get 10 bits of data out of the ADC) Don't pay attention to values from unconnected (floating) inputs. Lower channels will "leak" over into higher, undriven channels and the terminal output gets quite noisy. Putting jumpers between signal and +5V gives clean readings (but double-check, the other position would short +5V to GND). The archived project is for PlanAhead, which comes with the ISE 14.7 download. This post has been promoted to an article impl.bit PapiliioProRetrocadeAdcDemo.pa.zip Quote Link to comment Share on other sites More sharing options...
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.