Search the Community

Hello all, after I searched through the forums and tried different options to no avail I would like to ask here for an opinion My problem is programming a papilio one 500 SPI Flash within Linux, esp. Kubuntu 13.10 Flash works ok and the papilio-loader-gui shows no errors For me all looks good so far. I disconnected and reconnected the USB cable without success. Within a Win 7 64bit everything works like a charm (that is Flash and SPI are configured successfully) Any ideas? Thank you for reading Best regards Peter Using devlist.txtJTAG chainpos: 0 Device IDCODE = 0x41c22093 Desc: XC3S500EUsing devlist.txtJTAG chainpos: 0 Device IDCODE = 0x41c22093 Desc: XC3S500EUploading "/opt/GadgetFactory/papilio-loader/programmer/bscan_spi_xc3s500e.bit". Done.Programming time 223.0 msProgramming External Flash Memory with "/home/peter/Programming/fpga/1test/encoder_xilinx_bsp/main.bit".Found SST Flash (Pages=2048, Page Size=264 bytes, 4325376 bits).Programming :..............Finished ProgrammingOkDone.SPI execution time 12232.0 msUSB transactions: Write 727 read 10 retries 20Using devlist.txtJTAG chainpos: 0 Device IDCODE = 0x41c22093 Desc: XC3S500EISC_Done = 1ISC_Enabled = 0House Cleaning = 1DONE = 1