Programing Error Codes

[T.Creemer 0]

I'm new to the Papilio world.  I've created a new .bit file to change some basic functionality within a design.  I now get 0x19 or 0x11 as an error code.  (failed to configure).  

Where can I find a detailed description of these error codes?

 

Thanks in advance for any help.

[Jack Gassett 0]

Hello,

Did you get this resolved? 

If not can you post the full error message?

I also suggest comparing the *.xise file with a known good xise file using a text editor to see what the differences might be.

Jack.

[T.Creemer 0]

I did get past the problem, but with no resolution on the the error codes.  I have control lines from several analog multiplexers connected to the free port I/O pins.  For some reason during programing, power must be applied to these devices.  Apparently they are holding I/O lines on the FPGA in a state that causes the issue.  

Thanks for checking.