sekyondai 0 Report post Posted February 7, 2016 Hello, I have a papilio board that is not programing. I get not output from the Papilio loader when trying to program it so I am unable to provide an error message. All I get from the board is blinking leds (I have the logic start megawing attached to it) See screenshot attached... Any ideas? Share this post Link to post Share on other sites
Jack Gassett 0 Report post Posted February 8, 2016 Hello, What OS are you using? Also, which Papilio board are you using? Finally, do you see the device show up in Device Manager under Windows or with lsusb under Linux? Thanks,Jack. Share this post Link to post Share on other sites
sekyondai 0 Report post Posted February 9, 2016 Hello Jack, I am mainly using linux (Debian) but I did try it on a windows 7 machine as well. I am using the papilio one. It definitely shows up in linux with the lsusb command. Share this post Link to post Share on other sites
Jack Gassett 0 Report post Posted February 9, 2016 Does it work under Windows? Can you use just the papilio-prog application by itself? Jack. Share this post Link to post Share on other sites
sekyondai 0 Report post Posted February 10, 2016 Jack, I can see the papilio in device manager on windows but it does not work either. It does not work when I use the papilio-prog application by itself. It just sits there in the terminal and I eventually have to kill it (Ctrl + C). Share this post Link to post Share on other sites
Jack Gassett 0 Report post Posted February 10, 2016 Hmm, maybe it is a bad board. If you send us an email at support@gadgetfactory.net and provide a link to this thread and your current shipping address we will ship you out a replacement board. Jack. Share this post Link to post Share on other sites
mkarlsson 34 Report post Posted February 10, 2016 Try this cmd line and tell what you see:papilio-prog -v -j Magnus Share this post Link to post Share on other sites