hrh118

Pmod Connector

Recommended Posts

Initially when the Kickstarter campaign started Jack said he was able to squeeze a Pmod  connector onto the Papilio Duo PCB.   Did a Pmod connector make it into the final version of the PCB?    If not any suggestions on how to connect a Pmod device to a Papolio Duo? 

 

Howard

Share this post


Link to post
Share on other sites

Hello Howard,

 

One PMOD connection did make it onto the final version of the board, but I have never tested it as I don't own any PMOD's yet...

 

Please look at this link, the highlighted section on the bottom made it into the final board and should accept a PMOD.

 

Please let me know how it goes if you give it a try.

 

Jack.

Share this post


Link to post
Share on other sites

Helo Jack.

 

Thank you for your reply.

In looking at the Pin Out Schematic and the PCB board layout it is not obvioud to me whch pins are designated for use with a 6 pin Pmod connector.  I woud appreciate a few hints.

 

Howard

Share this post


Link to post
Share on other sites

It looks fairly obvious to me. The wing socket at the back right (looking at the Duo from the top with the USB sockets towards you) does dual duty as a PMOD socket. Wings are normally 4x3, you drop the back row of the Wing socket and add the 4 new pins for power and ground.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now