Tzjnto 0 Report post Posted August 15, 2014 Hey,I was wondering if i could use the loader to program my own fpga board (which has a XC6SLX9-3TQG144C) ?The board has FT2232H installed as the Papilio schematic instructed.(sorry for bad english) Share this post Link to post Share on other sites
Jack Gassett 0 Report post Posted August 15, 2014 Yes, it should work.Jack. Share this post Link to post Share on other sites
Tzjnto 0 Report post Posted August 16, 2014 Thanks. Share this post Link to post Share on other sites
offroad 14 Report post Posted August 16, 2014 You could also use xc3sprog, Papilio loader is a customized version of that. For example, to program a different FPGA size or use a separate JTAG interface. Share this post Link to post Share on other sites
Tzjnto 0 Report post Posted August 20, 2014 got a new problem, i dont know how to program the eeprom and make ft2232 work in MPSSE mode.i got some codes for enabling it but i dont know where should i put them and how can i use them. can someone help me ? Share this post Link to post Share on other sites
Jack Gassett 0 Report post Posted August 20, 2014 There is no need to program the eeprom for the ft2232 to work in MPSSE mode. By default it will work, so if the eeprom is blank or you don't even have a eeprom then you can still go into MPSSE mode. You just need the eeprom to program a VID/PID and go into some special modes like the optical mode. Jack. Share this post Link to post Share on other sites