Moonknight

Can not upload retrocade 01.d

Recommended Posts

Hmmm, that is weird. That's usually an indication that the board is not getting power or it is not being picked up with the drivers by the operating system.

Can you bring up the device manager and just plug the Papilio Pro board into your computer? Make sure that the PWRSELECT jumper didn't somehow come off the board and that it is connected between pins 1 and 2 which selects USB power. When you plug it into the computer you should see Papilio Com ports show up in the device manager.

You can try to re-install the Papilio drivers by going into the directory where RetroCade was installed (C:\Program Files (x86)\Gadget Factory) and going into the Papilio USB Drivers directory. Run install.bat and that should re-install the drivers.

Keep me posted, if needed we can setup a time where I can be in chat to help you get it up and running.

Thanks,

Jack.

Share this post


Link to post
Share on other sites

Jack

Sorry for the late answer but I was tied up in other stuff.

Seemed to be the jumper, even if it was still connected, just moving it a little bit and now it works ok. Thank you for your support.

- Chand

Share this post


Link to post
Share on other sites

Excellent Chand,

BTW, I put out a 1.0 release a couple days ago, it's under the download section. The only problem is that I put a bunch of mod and YM files on the SPI Flash which won't fit on the prototype hardware you have. So attached to this message is a bit file with the 1.0 firmware but without the mod and ym files in SPI Flash. It will let you put YMD and MOD files on the SD card.

Once your production hardware arrives you will be able to use the full release file.

Jack.

RetroCade-1.0-noSPI-zpuino-1.0-PapilioPro-S6LX9-RetroCade-1.0.bit

Share this post


Link to post
Share on other sites

Jack, just tried this file now *very late indeed, but can not flash this one to the prototype Papilio. However I received the new package, and it works great. So much fun!!

 

Thank You!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now