Search the Community

Showing results for tags 'problems'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • GadgetBox Universal IoT Hardware
    • GadgetBox General Discussion
  • Papilio Platform
    • Papilio General Discussion
    • Papilio Pro
    • Papilio One
    • Papilio DUO
    • Papilio Wings
    • DesignLab IDE
    • DesignLab Libraries
    • RetroCade Synth
    • Papilio Arcade
    • Papilio Loader Application
    • Papilio Logic Sniffer
    • Retired
  • Electronics
    • Modules
  • Soft Processors
    • ZPUino
    • J1 Forth
    • AVR8 Soft Processor
  • Community
    • Gadget Factory
    • Documentation
    • FPGA Discussions
    • Community Projects
    • Pipistrello
  • Open Bench
    • Open Bench Logic Sniffer at Dangerous Prototypes
    • OpenBench Logic Sniffer at Gadget Factory
  • Gadget Factory Internal Category

Categories

  • Papilio Platform
    • Papilio One
    • Papilio Plus
    • Papilio Wings
    • LogicStart MegaWing
    • ZPUino
    • Papilio Pro
  • Papilio Arcade
  • RetroCade Synth
  • Logic Sniffer
  • FPGAs
  • DesignLab
    • Example Projects
    • Libraries

Categories

  • Papilio FPGA
    • Papilio UCF (User Constraint) Files
    • Papilio Bit Files
  • Papilio Arcade
  • RetroCade Synth
  • General
  • Beta (Test) Releases
  • Books

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. I received my Papilio (250k) a short time ago and started to go through the documentation then discovered I needed a MegaWing. It arrived today so I went through the steps and programmed the board with Switches_LED.bit. All of the 7-segment displays lit up and none of the switches control any of the leds (all off). Double checked everything and went to the forums where I find someone with a similar problem. There was a note about changing the code to address different pins (MSB vs LSB). Tried that; no change. Tried Quickstart-Papilio_One_250K-v1.5.bit; all even-numbered leds blink, switches do nothing. I noticed that the behavior changed if I touched some of the pins near the switches. I could move my fingers around and get one, two, or three of the leds to stop blinking. Seemed to me like one of the supplies needed some more capacitance. Used my o'scope to check the supplies and found 5V was clean, 3.3V had about 400mV of a sawtooth and the 2.5V had a smaller amount of the sawtooth. Touching the scope probe to various pins causes different leds to stay on. The sawtooth changes from 20kHz to 47kHz at what seems to be the same rate as the leds turn on and off. I inspected all of the solder joints on both boards, I didn't find any cracked joints. There were a couple of solder splashes on the MegaWing (not mine, I only soldered the connectors on the Papilio) and a large blob of solder wicked up on the leads of C3 but otherwise, the board looked good. Any help? PS. Won't be online tomorrow --