kb_foo

Members
  • Content count

    3
  • Joined

  • Last visited

Posts posted by kb_foo


  1. Hello, 

     

    I'm just getting started with my new board. I'm running it on Mac (OSX 10.8) and followed the instructions for installing the Papilio Loader with no problems. When I connect the board via USB and try to run the QuickStart bit file I get the following error:

     

    Could not access USB device 0403:6010. If this is linux then use sudo.

     

    Running with sudo from the command line doesn't seem to help. I've also tried a few different USB cables (after reading some helpful posts on the forum.) The device does show up in my system information panel, like so:

     

    Dual RS232:

      Product ID: 0x6010

      Vendor ID: 0x0403  (Future Technology Devices International Limited)

      Version: 5.00

      Speed: Up to 12 Mb/sec

      Manufacturer: FTDI

     

    And, after installing some new drivers from FTDI, I was able to get it to show up in my /dev folder: 

     

    /dev/cu.usbserial-000012FDA  /dev/tty.usbserial-000012FDA
    /dev/cu.usbserial-000012FDB  /dev/tty.usbserial-000012FDB
     
     
    Any additional thoughts you all might have would be greatly appreciated! Thanks!