kb_foo

Members
  • Content count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral

About kb_foo

  • Rank
    Newbie

Profile Information

  • Gender
    Not Telling
  1. Well, the board worked fine on a friend's Mac, so I went back to this thread and carefully followed Guest_vtjnash's post, using the loader code straight from Github, rather than the Mac Installer. I'm not sure what changed! But everything seems to be working fine now. Thanks for all the help!
  2. I'm on Mountain Lion (10.8.5), but I checked and I don't have that FTDI driver loaded.
  3. Hello, I'm just getting started with my new board. I'm running it on Mac (OSX 10.8) and followed the instructions for installing the Papilio Loader with no problems. When I connect the board via USB and try to run the QuickStart bit file I get the following error: Could not access USB device 0403:6010. If this is linux then use sudo. Running with sudo from the command line doesn't seem to help. I've also tried a few different USB cables (after reading some helpful posts on the forum.) The device does show up in my system information panel, like so: Dual RS232: Product ID: 0x6010 Vendor ID: 0x0403 (Future Technology Devices International Limited) Version: 5.00 Speed: Up to 12 Mb/sec Manufacturer: FTDI And, after installing some new drivers from FTDI, I was able to get it to show up in my /dev folder: /dev/cu.usbserial-000012FDA /dev/tty.usbserial-000012FDA/dev/cu.usbserial-000012FDB /dev/tty.usbserial-000012FDB Any additional thoughts you all might have would be greatly appreciated! Thanks!