kevin_ipr Posted May 26, 2017 Report Share Posted May 26, 2017 I could manage to assign IP address to the Arduino ethernet shield mounted on Papilio Duo board, But when I tried to establish communication using TCP/IP, collision was detected by the ethernet shield. I think it must be because of the common SPI bus shared by both AVR microcontroller and Xilinx FPGA. Is there any work-around solution of the problem? I used Ethernet library from Arduino IDE. At present Xilinx FPGA is disabled, but in next stage I will be using wishbone bus shared registers. Quote Link to comment Share on other sites More sharing options...
Jack Gassett Posted May 30, 2017 Report Share Posted May 30, 2017 I have never tried out the ethernet shield with the Papilio DUO so not sure what the problem is that you are running into... If you load a blank circuit to the FPGA side then there should not be any conflicts... You could also try to use one of these types of ethernet modules: http://store.gadgetfactory.net/ethernet-module/ Jack. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.