RicoC Posted July 19, 2013 Report Share Posted July 19, 2013 Just got my RetroCade Synth and having some problems getting going. When I plug in the USB the LCD is blank for a few seconds, then a row of blocks flashes on the lower half of the screen. The audio outputs a clicking sound. There wasn't an upgrade fimware file in the installer but I don't see any recent upgrades so I'm assuming I have the latest. Bit of a newbie here so apologies if I'm missing something obvious. Link to comment Share on other sites More sharing options...
Jack Gassett Posted July 19, 2013 Report Share Posted July 19, 2013 Hello RicoC, It sounds like you need to install the latest RetroCade Firmware. Please follow this Getting Started Guide to get the firmware loaded. If you run into any difficulties or have any questions please ask here, I will try to watch this thread closely. Jack. Link to comment Share on other sites More sharing options...
RicoC Posted July 19, 2013 Author Report Share Posted July 19, 2013 Thanks for the reply Jack... I was trying to follow the guide but couldn't find the Upgrade Firmware file, it isn't in my Start menu or the Gadget Factory folder... Rico Link to comment Share on other sites More sharing options...
RicoC Posted July 19, 2013 Author Report Share Posted July 19, 2013 OK I found it! Proceeding to run... Link to comment Share on other sites More sharing options...
RicoC Posted July 19, 2013 Author Report Share Posted July 19, 2013 ...and it works! Awesome. Should have persevered before bugging you but thanks again for the swift support. R. Link to comment Share on other sites More sharing options...
Jack Gassett Posted July 19, 2013 Report Share Posted July 19, 2013 No problem, glad you got it working. Jack. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.