PicoTheDog Posted October 22, 2012 Report Share Posted October 22, 2012 Hi All,Could someone post easy steps how to get ZPUino running on custom board? I have old spartan 3A 400k evaluation board from Avnet and it would be great to get ZPUino to say hello world from that board.I have taken papilio one 250k project as a base and edited papilio_one.ucf to match my pins in Avnet board. I also had to remove Wing C pin mappings because I don't have enough IOs in Avnet board. I changed clock frequency to 16 MHz instead of 32 MHz (does this have an affect on anywhere else than ucf?).I also edited zpuino_config.vhd zpuino_gpio_count to match new number of IOs.Currently I can get to place & route where routing fails to route zpuino/stack_a_read<16> signal for some reason.Br, Pico Link to comment Share on other sites More sharing options...
alvieboy Posted October 23, 2012 Report Share Posted October 23, 2012 Hi,can you please send me more details via email ? I need all information regarding that board.Yes, there are many other things needed in order to port ZPUino to another board. Link to comment Share on other sites More sharing options...
PicoTheDog Posted October 31, 2012 Author Report Share Posted October 31, 2012 Hi Alvie,I put e-mail to alvieboy at alvie.com address last week. Did you receive the e-mail or is the e-mail I used still valid?I think some walkthrough how to use zpuino in any custom board would help others too. Could someone post steps how to do that?Br, Pico Link to comment Share on other sites More sharing options...
alvieboy Posted November 5, 2012 Report Share Posted November 5, 2012 Yes, I did.Sorry, I've been moving to a new house, so most of my email is delayed. I promise to answer you during this week.Alvie Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.