Last night I ported my unfinished MC6847 emulator Verilog code from a Altera EPC4 board to my Papilio One. I have the small VGA wing, which has: hsync; vsync; and 2 bits each for R, G and B. When I found the schematic I was surprised to see that both resistors were the same value, which I believe will only allow my 3 levels of luminance for each colour, so only 27 colours in total. Why not use two different values for the resistors, similar to the scheme used on the other MegaWings? To be honest it isn't an issue for this particular project. I know that I could replace one of the resistors, but I am unable to work with that tiny size of SMD resistor.