Search the Community: Showing results for tags 'unexpected behavour'.
Found 1 result
Hello, Im having a problem with the wishbone interface on the ZPUino soft processor. I am trying to output a signal to a design I have made, in this instance its outputting a reset signal but the same problem occurs on all the other outputs too. The signal and corresponding pin I have the oscilloscope connected to is highlighted in red in fig 1. This goes to a custom block that builds individual signals into a bus that is outputted using the Papilio block set provided, this can be seen in fig 2. Im using the standard ZPUino programing IDE, when I program it to output 0xff to wishbone Register 2 the output pin on the FPGA becomes high, this is shown in figure 3. This is exactly what you would expect to happen. Again in fig 4 the when Register 2 is set to be 0x00 then the output on the pin connected to the oscilloscope is set to logic 0, as expected. However in figure 5 Wishbone register 2 is set to be 0x00 for 100ms then set to 0xff for 200ms, this should produce a waveform that shows a signal that is high twice as long as low. Though this is the comes out as the opposite, it seems that the signal is being inverted. I can’t for the life of me work out why this is. Similarly in fig 6 I set it to be the opposite 0xff for 200ms and 0x00 for 100ms and it does the same, inverting the signals again. I have checked for sources of error in other places, the oscilloscope is working fine Ive tried connecting the Wishbone output directly to a pin to see if the Papilio output block was the cause this had no effect, I’ve double checked my Wishbone interface code its fine no reason to invert the output. This also happens when the delay is increased to 20secconds and 10secconds to see if it was a timing issue and needed a steeling time, keeps inverting the signals still. The weird thing is that it works fine when the is no periodic signal applied and its just a DC output, if it was an inverter causing the problem that’s fine all I need to do is change my code around a bit but this is not that simple and I couldn’t work with an unpredictable output. Does anyone have any suggestion as to what the problem is? Many thanks Joe