Search the Community
Showing results for tags 'papilio one'.
-
Hello I need quick start .bit file of papilio one 100k version. Thanks.
- 9 replies
-
- Papilio one
- 100k
-
(and 2 more)
Tagged with:
-
Hi everyone, I have a papilio pro working successfully with designlab but I want to use a custom board (like papilio one) with it. I've selected papilio one 250k and "Load circuit" seems to be ok, but when I tried to upload... the output is attached: "Cannot get programmer version, aborting". I've checked COM port, FTDI configuration EEPROM is empty (with FT_prog), papilio drivers are loaded... I also tried to change some values in the FPGA (HSWAP is '0' so every pin will be pullup, but I've pulled up M0 and M2, and M1 to GND. Also "Done" and "init b" pulled up.)... Any help? My XC3S250E has different IDCODE so I've added this line to the devlist.txt file: Papilio-prog seems to work good. What is the problem? Thanks
- 13 replies
-
- papilio one
- custom board
-
(and 2 more)
Tagged with:
-
- 3 comments
-
- FPGA
- Logic Analyzer
-
(and 1 more)
Tagged with:
-
Hello For production purpose, i need polygon clearance modified altium design file of papilio one (at least 12 mil clearance), after successfully importing eagle files i tried to increase the clearances but i didn't succeed. Maybe it's because of it's specific polygon pouring used for ground and power tracks.
- 5 replies
-
- Papilio one
- polygon
-
(and 2 more)
Tagged with:
-
Hello It is possible to replace 93LC46B serial eeprom with 93C46B (as i checked the difference is in supply voltage range, that is 2.5-5.5 volts for 93LC46B and 4.5-5.5 volts for 93C46B)?
- 1 reply
-
- papilio one
- serial
-
(and 1 more)
Tagged with:
-
Hello I decide to assemble papilio one myself, is it possible to replace it's original spi flash with AT45DB161D-SU or AT45DB321D-SU? Thanks.
- 4 replies
-
- spi flash
- replacement
-
(and 1 more)
Tagged with:
-
- 1 comment
-
- Papilio One
- Papilio Arcade
-
(and 2 more)
Tagged with:
-
I purchased these two products from your site in a bundle with a USB cable about 2 months ago and I've recently been having problems with them. Whenever I try to connect them to any computer, the computer doesn't recognize that they are there. They can't be found when I attempt to send bit files to them either. However, they do seem to receive power as the LED's light up. I would like to know if there is a quick fix for this or what else I can do, thanks.
-
-
- AVR8
- Soft Processor
-
(and 2 more)
Tagged with:
-
-
- Papilio One
- FPGA
-
(and 1 more)
Tagged with: