Search the Community: Showing results for tags 'chipscope'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • GadgetBox Universal IoT Hardware
    • GadgetBox General Discussion
  • Papilio Platform
    • Papilio General Discussion
    • Papilio Pro
    • Papilio One
    • Papilio DUO
    • Papilio Wings
    • DesignLab IDE
    • DesignLab Libraries
    • RetroCade Synth
    • Papilio Arcade
    • Papilio Loader Application
    • Papilio Logic Sniffer
    • Retired
  • Electronics
    • Modules
  • Soft Processors
    • ZPUino
    • J1 Forth
    • AVR8 Soft Processor
  • Community
    • Gadget Factory
    • Documentation
    • FPGA Discussions
    • Community Projects
    • Pipistrello
  • Open Bench
    • Open Bench Logic Sniffer at Dangerous Prototypes
    • OpenBench Logic Sniffer at Gadget Factory
  • Gadget Factory Internal Category

Categories

  • Papilio Platform
    • Papilio One
    • Papilio Plus
    • Papilio Wings
    • LogicStart MegaWing
    • ZPUino
    • Papilio Pro
  • Papilio Arcade
  • RetroCade Synth
  • Logic Sniffer
  • FPGAs
  • DesignLab
    • Example Projects
    • Libraries

Categories

  • Papilio FPGA
    • Papilio UCF (User Constraint) Files
    • Papilio Bit Files
  • Papilio Arcade
  • RetroCade Synth
  • General
  • Beta (Test) Releases
  • Books

Found 1 result

  1. Hello, I have tried to connect my XILINX Platform Cable USB to the Papilio Duo. To avoid interfere of the FTDI Chip and the programmer I changed the PORTA of the FTDI to optically isolated mode as described here: https://www.youtube.com/watch?v=JqMJ_AdK1sw. The device ID can be read out as shown there, but programming is not possible with the impact tool o Xilinx. The papilio loader works, when the platform cable is disconnected. In the end of the video the FTDI chip is resetted by erasing the EPROM completely with FT_PROG. I have several questions: - since the programming is not possible from impact using Platform Cable and, in my case, programming is also not possible with playtag (http://forum.gadgetfactory.net/index.php?/topic/1896-papilio-board-support-in-xilinx-tools-like-impactchipscope-etc/) from inside impact, what are possible adjustments to program from impact and to use chipscope? I consider removing FTDI Chip completely using hot air soldering and using Platform Cable solely. - The video shows resetting the FTDI completely by erasing the EPROM. This erases the complete intital configuration. I lost my backup file. Can you please provide the initial configuration file for FTDIs FT_PROG to be able to use Papilio Loader again? Can you please make a hint in the video that a save backup of the fie is necessary? Why is erasing the eprom an option? In my case the board is not programmable anymore. A short - but complete and correct – introduction on how to use the papilio duo board successfully from within ISE Webbench in combination with impact and chipscope would be a great help. I guess for some more people than me. Thank you very much.