Search the Community: Showing results for tags 'Stepper Motor'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • GadgetBox Universal IoT Hardware
    • GadgetBox General Discussion
  • Papilio Platform
    • Papilio General Discussion
    • Papilio Pro
    • Papilio One
    • Papilio DUO
    • Papilio Wings
    • DesignLab IDE
    • DesignLab Libraries
    • RetroCade Synth
    • Papilio Arcade
    • Papilio Loader Application
    • Papilio Logic Sniffer
    • Retired
  • Electronics
    • Modules
  • Soft Processors
    • ZPUino
    • J1 Forth
    • AVR8 Soft Processor
  • Community
    • Gadget Factory
    • Documentation
    • FPGA Discussions
    • Community Projects
    • Pipistrello
  • Open Bench
    • Open Bench Logic Sniffer at Dangerous Prototypes
    • OpenBench Logic Sniffer at Gadget Factory
  • Gadget Factory Internal Category

Categories

  • Papilio Platform
    • Papilio One
    • Papilio Plus
    • Papilio Wings
    • LogicStart MegaWing
    • ZPUino
    • Papilio Pro
  • Papilio Arcade
  • RetroCade Synth
  • Logic Sniffer
  • FPGAs
  • DesignLab
    • Example Projects
    • Libraries

Categories

  • Papilio FPGA
    • Papilio UCF (User Constraint) Files
    • Papilio Bit Files
  • Papilio Arcade
  • RetroCade Synth
  • General
  • Beta (Test) Releases
  • Books

Found 1 result

  1. Hi! I am trying to use a Papilio Pro to run a stepper motor since the Teensy, Arduino microcontrollers proved insufficient for my purposes. I am interfacing the Papilio pro with the L6470 IC which is going to be the motor driver. My main problem is this - I am keen on using a Python module to control the stepper motor but I have no clue as to how to go about writing the code for the Papilio Pro which will be the board that will receive the bits sent via the Python code and will reroute it through the IC which will translate that in to stepper motion. The bits here are basically my position, speed values, etc. I have plans for sending entire waveforms, say, to make the motor oscillate between two positions and so on. I was wondering how I should go about this project?